Research use resources

ARA-290 lab report: what to check on an ARA-290 (cibinetide) COA

Three Prestige research vials in a row

ARA-290, now also known by the name cibinetide, is a synthetic peptide of 11 amino acids. Two features shape its lab report: it starts with pyroglutamic acid, a ring that forms from glutamic acid, and it has no amino acid that absorbs ultraviolet light strongly, which decides how its purity is measured. This guide covers what an ARA-290 certificate of analysis (COA) should show and what to check first. For the basics of any report, see How to read a peptide lab report.

The short version

Purity (HPLC)One main peak with no large peak right beside it. 98% or higher is the usual standard.
Identity (mass spec)A measured mass that matches ARA-290, the ringed start included.
ContentMilligrams of ARA-290 in the vial, compared with the 10mg on the label.
Either nameARA-290 and cibinetide are the same peptide; the sequence is what to match.

What ARA-290 is, chemically

ARA-290 is a straight chain of 11 amino acids, designed in laboratory work from one face of the erythropoietin molecule (the part called helix B). Its first amino acid is pyroglutamic acid (pGlu): a glutamic acid whose side chain has closed into a small ring with the start of the chain. That ring caps the start of the peptide, so there is no free amino end.

pGlu1GluGlnLeuGluArgAlaLeuAsn9SerSer
ARA-290, eleven amino acids. Pyroglutamic acid (position 1), the ringed start, and asparagine (position 9), the two spots most worth knowing on a report.
Reference factARA-290, as on our product page
Other nameCibinetide
SequencepGlu-Glu-Gln-Leu-Glu-Arg-Ala-Leu-Asn-Ser-Ser
Length11 amino acids
FormFreeze dried (lyophilized) powder, 10mg vials

Purity: what to look for on the trace

Purity comes from HPLC: the sample runs through a column, a UV detector draws a peak for each component, and purity is the main peak’s area as a share of every peak. ARA-290 has no amino acid with a ring that absorbs strongly at 280 nm, so the detector reads it at a low wavelength, around 214 nm, where the bonds between amino acids absorb. A report should name its wavelength. The small peaks worth knowing on an ARA-290 trace are:

  • The open form. If the pyroglutamic ring did not form fully in synthesis, a version starting with plain glutamine or glutamic acid can remain. It differs in mass, so mass spec can tell it apart.
  • A changed asparagine. Asparagine (position 9) can slowly lose its amide group and turn into aspartic acid, especially with moisture and warmth. The changed form runs as a small peak near the main one.
  • Chains missing an amino acid, left from a synthesis step that didn’t finish.

Moisture speeds up the asparagine change, which is one reason the powder is kept sealed, dry and cold. See How to store lyophilized peptides.

Identity: what mass spec confirms

Mass spectrometry weighs the main peak and confirms it is ARA-290. Forming the pyroglutamic ring releases a small molecule, so the ringed peptide weighs a little less than the same chain starting with glutamine. A report that states the measured mass matches ARA-290 confirms the ring is there. With two glutamic acids and an acid group at its end, ARA-290 can also show a sodium signal next to the main one in the instrument; it is the same molecule, not an impurity.

Content: milligrams, not percent

Content is how many milligrams of ARA-290 the lab measured in the vial. The powder also holds salts and a little water, so content and purity are separate numbers. A report that gives content per vial, in milligrams or as a percent of the label, answers the question the label asks. More in Purity vs content.

Our ARA-290 reports

ARA-290 is new on our site. Independent lab reports are linked on its product page as they come in; none is posted yet. Contact us and we will send the documentation for the lot you receive. When a report is posted, the checks below are the ones to run on it.

Checking an ARA-290 report, step by step

  1. Name and sequence: ARA-290 or cibinetide, pGlu-Glu-Gln-Leu-Glu-Arg-Ala-Leu-Asn-Ser-Ser.
  2. Purity from HPLC, 98% or higher, with the wavelength named.
  3. Identity from mass spec: the report states that the measured mass matches ARA-290.
  4. Content in milligrams, close to or above the 10mg on the label.
  5. The lab and report number, matching the report linked on the product page.

Common questions

Are ARA-290 and cibinetide the same?

Yes. ARA-290 is the research code and cibinetide the name given to the same 11 amino acid peptide. Reports may use either; the sequence is what to match.

What does pGlu mean in the sequence?

Pyroglutamic acid: a glutamic acid whose side chain has closed into a ring with the start of the chain. It is the first amino acid of ARA-290.

Where will the ARA-290 report be?

On the ARA-290 product page under Specifications & documentation, and on our research materials page, which lists every report.